FAQ – i-Mend Self Mending Deck

• Will the i-Mend Deck work with my die cutting machine?
  Our Decks will work with most physical die cutting machines with a 6 1/8″ opening. This includes hand-cranked and electric machines.

• Will this work with my Cuttlebug machine?
  Our Decks are 6 1/8″ wide and will not fit a Cuttlebug machine. 

• Will the i-Mend Deck work with my Gemini Jr machine?
  When used properly, the i-Mend Deck will work with the Gemini Jr machine. Use their standard recommended sandwich for thin metal dies. IMPORTANT: Flip and/or rotate the i-Mend Deck after each pass for longer wear. May require thin shims for best results.

• Will the i-Mend Deck work with the Vagabond machine?
  Yes if used properly and flipped and/or rotated after each pass.
  

• Can I use the i-Mend Deck with the Sizzix Precision Base Plate?
  No. Note that your results may vary if you use a thin metal die that has previously been used with the Sizzix Precision Base Plate due to the compromised cutting surface of the dies.

• How do I clean my i-Mend Deck?
  If necessary, use a damp paper towel and cold water to wipe the i-Mend Deck surface clean. Do not use harsh detergents. Do not expose to hot water.
• Will the i-Mend Deck work with steel rule dies?
  Yes but it will increase surface wear.
• Can I use the i-Mend Deck with the i-Mend PRO Decks?
  Yes. You can use an i-Mend Deck in place of the hard cutting deck in your PRO Deck sandwich.